![]() ![]() ![]() I am not really sure what this error corresponds to, and it might be related to this red light, but if someone has a solution other than changing the module, I am all ears ! Here is my output : ~$ sudo qmicli -d /dev/cdc-wdm1 -p -wds-start-network="ip-type=4,apn=yesinternet" -client-no-release-cidĮrror: couldn't start network: QMI protocol error (14): 'CallFailed' $ sudo qmicli -p -d /dev/cdc-wdm0 -wds-start-network="apn='YOUR_APN',username='YOUR_USERNAME',password='YOUR_PASSWORD',ip-type=4" -client-no-release-cid ![]() Once the wwan0 is up, connect the mobile network by changing the apn='YOUR_APN',username='YOUR_USERNAME',password='YOUR_PASSWORD' part of the line according to the information of your SIM & operator: However, I am stuck to this following step : You will find below the errors I encountered while trying to set up QMI on this second DevKit.Įvery first sets of Linux commands seem to work. Lighting: Overcurrent detected in module power pass, change module, restart LGA DevKit's power supply One seems to work just fine (only pinging from wwan0 isn't successful yet), but the second DevKit has its TXD0 LED lighting up in red, and that's what the datasheet says about red light : I have 2 LGA DevKits with PLS83-W module implemented. I have been following this tutorial : PLS63/83 QMI/RMNET Setup and Linux qmi_wwan / ModemManager Integration | Thales IoT Developer Community () to configure the PLS83-W module to operate in QMI/RMNET. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |